jammr Forum

I have a Behringer U-PHORIA UMC202HD USB Audio Interface, and am wondering if Jammr software will handle devices connected through it?

Hi PhilFox,
That interface should work fine. Note that jammr only captures the first input on an audio interface, so make sure to connect your mic/instrument to the first input.

PhilFox, did it work for you.
I am trying to go thru same method and all I get is loud scratching noises.

Not sure what the settings on jammr should be.

Stefanha, could you please guide?

Hi, I'm having a problem setting the Audio source in “Preferences”. The ‘Audio’ source is greyed out and set to “Built-in Audio”, and I can't change it to my sound card. Any ideas? Thanks

jazzwhistle
Hi, I'm having a problem setting the Audio source in “Preferences”. The ‘Audio’ source is greyed out and set to “Built-in Audio”, and I can't change it to my sound card. Any ideas? Thanks

I found the answer in this forum. Here's what I did:

1. Open jammr app
2. Login
3. Close “connect to server” window
4. Open preferences
5. Under “Audio”, input and output devices may be changed (not greyed out)

Frankly, this seems confusing, and it would make more sense to not automatically have the “connect to server” window open after login (or at least make it an option to disable that behavior under preferences).

Edited validnode (March 23, 2020 21:22:56)

ndesai
PhilFox, did it work for you. I am trying to go thru same method and all I get is loud scratching noises. Not sure what the settings on jammr should be.Stefanha, could you please guide?

If there are audio glitches it's usually because the sample rate and latency settings are not working well for this device. Most devices run fine at 44100 Hz or 48000 Hz.

Latency should normally be between 5-12 milliseconds. The lower you set it, the less delay you feel when playing but setting it too lower will cause audio glitches when the computer can't keep up.

jazzwhistle
Hi, I'm having a problem setting the Audio source in “Preferences”. The ‘Audio’ source is greyed out and set to “Built-in Audio”, and I can't change it to my sound card. Any ideas? Thanks

Please disconnect from a jam session in order to change audio settings.

Can't see how I missed that! Thanks a lot

Hi,
I try to connect with Blackstar ID:CORE comboamp, connected via the USB to my PC. I have it selected as default input device and I can hear myself in the headphones through it, however when I connect to Jammr I get the error provided below.

AV
Hi, I try to connect with Blackstar ID:CORE comboamp, connected via the USB to my PC. I have it selected as default input device and I can hear myself in the headphones through it, however when I connect to Jammr I get the error provided below.

Hi AV,
Please upload the attachment again. Thanks!